Showing 17–29 of 29 results
The Tool Steel Ring is a standardized test piece commonly used with wet bench magnetic particle equipment. The ring is machined from AISI O1 Tool Steel, annealed, tested and certified to meet AS 5282 specifications.
The Y-2 is an AC electromagnetic yoke, ergonomically designed to improve productivity and reduce operator arm and wrist fatigue. The yoke generates a strong AC magnetic field for the detection of surface indications during magnetic particle testing.
Lightweight with an ergonomic grip and trigger, the Y-2 is designed for the rugged demands of field inspection. Featuring a field swappable cord and isolated trigger switch; the Y-2 is easily serviceable because a severed cord should not stop a job from getting done.
The LED yoke light is an add-on accessory for the Y-2 AC yoke which provides focused, visible light to the yoke inspection area when the yoke is activated. The high brightness light is designed to enhance visible detection of flaws and discontinuities under low conditions and in difficult to reach areas not accessible to a secondary light source.
The Yoke Test Weight is a certified 10 lb / 4.5 kg weight designed specifically for AC magnetic yokes to confirm the yoke has sufficient strength to perform magnetic particle inspections. Each Yoke Test Weight has a built-in leg positioning guide to assure balanced distribution and accurate test results.
A medium sensitivity penetrant (Level 2), ZL-2C fluorescent post-emulsifiable penetrant is designed to be removed from the part surface by emulsifiers or solvent.
With a UV-A light source, indications will appear as a bright green-yellow fluorescence.
ZL-2C has a high flash point, and is designed to be used in open dip tanks.
Essential for critical component applications, ultra-high sensitivity ZL-37 post-emulsifiable penetrant is designed for detecting fine, tight discontinuities in safety-critical components, such as titanium turbine components, and in high-stress parts, such as investment castings.
This Type 1 penetrant is non-water-soluble so there is minimal risk of washing ZL-37 penetrant from a fine or shallow defect which makes this penetrant inspection the most reliable, dependable form of PT testing.
ZL-37 has a high flash point and provides long tank life when used in open dip tanks, but this penetrant can also be applied in a variety of other ways, including electrostatic spray.
ZL-37 can be removed with ZE-4B Method B lipophilic emulsifier or ZR-10C Method D hydrophilic emulsifier.
Developed for testing rough machined surfaces, ZL-60C fluorescent water-removeable penetrant is ideal for finding indications in castings, forgings, extrusions and rough surfaces.
This medium-sensitivity penetrant washes off parts quickly and easily, leaving less fluorescent background – even on rough surfaces – for clearer indications and better inspection reliability. Broad specification compliance further increase this penetrants flexibility.
ZL-60C has excellent alloy compatibility and is safe to use on most engineering and aerospace materials, including aluminum, steel, nickel and titanium.
